diver.net

Din insert question on Steel 100 thermo valve





[ Follow Ups ] [ Post Followup ] [ California Scuba Diving BBS ] [ FAQ ]

Posted by bxavier on July 28, 2013 at 09:42:49:

Hello: just wondering about the size of orings on each side of the din insert. thermo valve says 3442 psi/230 bar. after reading some, it looks like the big oring is a 213 and the smaller is an 012. Is this correct? I'm having a little trouble blowing orings with a conventional 1st stage with 3400 psi, but I think I was using a cheap size 14 oring. also the insert is nicked up some. Please advise, as air is important under water. PS: the viz at Catalina Th. and Fri. was near 100 feet. thanks, Brian Xavier



Follow Ups:


Name:
E-Mail:
Subject:
Message:
Optional Link URL:
Optional Link Title:
Optional Image URL:
Post Background Color: White     Black
Post Area Page Width: Normal   Full
You must type in the
scrambled text key to
the right.
This is required to
help prevent spam bots
from flooding this BBS.
capcha
Text Key:

      


diver.net